2B-100 Solar Powered Perimeter Beams (DA600+)

These impressive 2B Solar Powered Wireless Perimeter Beams are packed with impressive features (listed below) and will work in conjunction with either of the Wireless Receivers (indoor 004-2790, 004-2880) & (solar outdoor 004-2810), perfect for protecting the outside of homes, farms & businesses:

• Work with all DA600+ products.
• Battery Powered with Built in Solar Charging: (making for easy installation).
• 2 x Dual Detection Technology Beams: (prevents false alarms from small animals and moving debris).
• 100 metre Detection: (covers more are with less detectors).
• Impressive 900 metre Wireless Range: 
• Quality Build.
• Supplied with Wall & Pole Mounting Brackets.
• Test Lights: (for easy installation).
• Top up charging Ports.

The Dual Detection Technology works by having a pair of Detectors (set 60 mm apart from each other) on each Beam, both Detectors have to be breached simultaneously to create an activation, allowing small animals, insects, leaves & debris to safely pass by. There are a pair of detectors on each size of Beam, so these 2B-100 Beams have two pairs.

The External Beams are also supplied with an additional Charging Port which can be used to give the Beams a boost charge should you experience a lengthy duration of low sun light, or perhaps one of the beams needs to be fitted into a slightly covered location. 

They are very easy to install as they have a built in Red Glow Light (for easy lining up).

These Beams can be set to operate a small siren for a few seconds when activated (pressing ON/OFF button 3 - 6 times, or OFF by pressing the same ON/OFF button 7 or 8 times).

You can use up to 128 sets of Beams with the Internal Receiver & 32 sets with the Solar Wireless Siren, you can mix & match by using a selection of different sizes of Beams within one single system.

The Wireless operating range between the Beams & Receivers is 900 metres (line of sight) which can be doubled by using the signal repeater (part number 004-2910).

Please Note: Work in conjunction with all DA600+ products !!

• 1 x Set of Solar Powered Detecting Beams.
• 1 x Set of Wall Mounting Brackets. 
• 1 x Set of Pole Mounting Brackets.
• 1 x Set of Instructions. 

• Beam Size: 590 (H) x 123 (W) x 45 (D) mm.
• Power Supply: Re-chargeable AA Batteries.
• Charging Method: Built in Solar Panels.
• Mounting Methods: Wall or Pole.
• Detection Range: 100 metres.
• Transmission Range: 900 metres (line of sight).
• Frequency: 433 Mhz.
• IP Rating: IP66.
• Distance Between Detection Beams: 60mm.
• Number of Beams: 2 sets.
• Charging Port: 9 - 12v DC (500 m/A to 1 amp).
• Built in Buzzer: Yes (turn on with 1 - 6 presses of button, off 7 or 8 times).
• Buzzer OFF (7 with immediate reset, 8 with 3 minutes battery saving reset).

Easy Programming Method:

1. Turn On Beams (switch on rear).
2. Mount the Beams.
3. Line up By Eye, String Line etc.
4. Put the relevant Receiver into Learn Mode.
5. Walk through the Beams, at this time (providing you have them correctly lined up), a low red glow will illuminate briefly.
6. The Signal sent to the Receiver from this set of beams will be learned into the relevant receiver.
7. Take the Receiver out of learn mode.
8. The system is now ready.